The circuit depicted here forms one half of a
device that will prove extremely handy when tracing the path of electrical
wiring in a building or to locate a break in a wire. The system is based on
similar equipment that is used by technicians in telephone exchanges. The
operation is straightforward. You require a generator that delivers an easily
recognizable signal which, using a short antenna, is inductively coupled to a
simple, but high gain, receiver. To create a useful transmitter it would suffice
to build a simple generator based on a 555. But as the adjacent diagram shows, a
556 was selected instead. The second timer (IC1a) is used to modulate the tone
produced by IC1b.
The
output frequency alternates between about 2100 Hz and 2200 Hz. This is a very
distinctive test signal that is easily distinguished from any other signals that
may be present. Resistor R6 is connected to a piece of wire, about ten
centimeters long, that functions as the antenna. The ground connection (junction
C2-C3) is connected to ground. When the antenna is connected directly to a
cable, it is possible to determine at the other end of the cable, with the aid
of the receiver, which conductor is which (don’t do this with live conductors!).
The schematic for the matching receiver may be found elsewhere in this website.
Back to
...